Energy, temperature, and deposition angle dependence of Cd and Te_2 deposited on CdTe Article (Faculty180)

cited authors

  • Amar, Jacques G; Khatri, Indiras

description

  • Cadmium Telluride (CdTe) is an important material for the production of high-efficiency thin-film solar cells. While sputter deposition has been used to create CdTe-based solar cells, two other important methods of growth are close-spaced sublimation and vapor deposition. In these methods, the depositing clusters correspond to Cd atoms and Te2 dimers while the deposition energies are relatively low. In addition, depending on vapor pressure, deposition method, and target-substrate distance, deposition may occur at relatively large angles with respect to the substrate normal. Here we investigate the dependence of the attachment probability and deposition site for Cd and Te2 clusters deposited on Cd-terminated and Te-terminated (100) and (111) surfaces of zincblende CdTe on deposition conditions. In general, we find that the deposition of Cd atoms and/or Te2 dimers on the oppositely terminated surface leads to an attachment probability which is close to 1 and relatively independent of deposition conditions for both the (100) and (111) orientations. In contrast, deposition on the same terminated surface leads to a significantly lower attachment probability which generally decreases with increasing deposition angle, energy, and substrate temperature. Our results also indicate that deposition on the (111) surface leads to a significant excess Te sticking probability. In contrast, the excess Te attachment probability for deposition on the (100) surface is typically significantly smaller, and in some cases may even be negative. We also find, for both deposition on the (111) surface as well as opposite termination deposition on the (100) surface, that the dominant deposition mode corresponds to sitting on top of the surface which corresponds to growth of the next layer. In contrast, for same termination deposition on the (100) surface the dominant deposition mode corresponds to joining the first layer. These results imply that even for low deposition energies and substrate temperatures, deposition on the (100) surface is likely to create interstitials in the surface layer.

publication date

  • 2020

published in

start page

  • 137798

volume

  • 697